Home » Technology » 13 Taibao for CNC machining center (13 maintenance secrets for CNC machine tools)! How many do you know?

13 Taibao for CNC machining center (13 maintenance secrets for CNC machine tools)! How many do you know?

Posted by: Chris Na 2021-05-26 Comments Off on 13 Taibao for CNC machining center (13 maintenance secrets for CNC machine tools)! How many do you know?

The correct operation and maintenance of the cnc machining center is one of the key factors for the correct use of CNC equipment;
1. Correct operation and use can prevent abnormal wear and tear of the machine tool and avoid sudden failures;
2. Do a good job of daily maintenance, which can keep the equipment in good technical condition, delay the deterioration process, find and eliminate hidden troubles in time, so as to ensure safe operation.
Attentions when the cnc machining center manufacturer is processing:
1. Before processing each program, it is necessary to strictly confirm whether the tool on the program is consistent with the program;
2. When installing the tool, please confirm the length of the tool and whether the selected tool holder is suitable;
3. It is forbidden to open the door during the operation of the machine tool to avoid flying knife or workpiece;
4. The operator must stop immediately if a tool collision is found during the processing, such as pressing the “emergency stop” button or the “reset button” or adjusting the “feed rate” to zero, etc.;
5. In the same workpiece, it must be kept in the same area every time the tool is set to ensure the accuracy of the tool when the tool is connected. The operation rules of the CNC machining center;
6. If you find that the machining allowance is too much during the machining process, you must use “single block” or “pause” to clear the values ​​of X, Y, and Z, then manually mill them out, and then shake them back to the “zero point” to let them go on their own run;
7. The operator of the cnc machining center manufacturer is not allowed to leave the machine tool or regularly check the operating status of the machine tool during its own operation. If it is necessary to leave halfway, the relevant personnel must be designated to check;
8. The aluminum slag in the machine tool must be cleaned before the light knife sprays oil to prevent the aluminum slag from absorbing oil;
9. Use air blowing as much as possible in the roughing program, and spray oil in the light knife program;
10. The workpiece must be cleaned and deburred in time after getting off the machine;
11. When leaving get off work, the operator must do a timely and accurate handover to ensure that the subsequent processing can be carried out normally;
12. Before shutting down, make sure that the tool magazine is in the original position, the XYZ axis is stopped in the center position, and turn off the power supply and the main power supply on the machine operation panel in turn;
13. When encountering a thunderstorm, the power supply must be cut off immediately to stop working.